Displaying similar documents to “A multi-model approach to Saint-Venant equations: A stability study by LMIs”

Control of an induction motor using sliding mode linearization

Erik Etien, Sébastien Cauet, Laurent Rambault, Gérard Champenois (2002)

International Journal of Applied Mathematics and Computer Science

Similarity:

Nonlinear control of the squirrel induction motor is designed using sliding mode theory. The developed approach leads to the design of a sliding mode controller in order to linearize the behaviour of an induction motor. The second problem described in the paper is decoupling between two physical outputs: the rotor speed and the rotor flux modulus. The sliding mode tools allow us to separate the control from these two outputs. To take account of parametric variations, a model-based approach...

Designing a ship course controller by applying the adaptive backstepping method

Anna Witkowska, Roman Śmierzchalski (2012)

International Journal of Applied Mathematics and Computer Science

Similarity:

The article discusses the problem of designing a proper and efficient adaptive course-keeping control system for a seagoing ship based on the adaptive backstepping method. The proposed controller in the design stage takes into account the dynamic properties of the steering gear and the full nonlinear static maneuvering characteristic. The adjustable parameters of the achieved nonlinear control structure were tuned up by using the genetic algorithm in order to optimize the system performance....

Supervisory predictive control and on-line set-point optimization

Piotr Tatjewski (2010)

International Journal of Applied Mathematics and Computer Science

Similarity:

The subject of this paper is to discuss selected effective known and novel structures for advanced process control and optimization. The role and techniques of model-based predictive control (MPC) in a supervisory (advanced) control layer are first shortly discussed. The emphasis is put on algorithm efficiency for nonlinear processes and on treating uncertainty in process models, with two solutions presented: the structure of nonlinear prediction and successive linearizations for nonlinear...

Verification techniques for sensitivity analysis and design of controllers for nonlinear dynamic systems with uncertainties

Andreas Rauh, Johanna Minisini, Eberhard P. Hofer (2009)

International Journal of Applied Mathematics and Computer Science

Similarity:

Control strategies for nonlinear dynamical systems often make use of special system properties, which are, for example, differential flatness or exact input-output as well as input-to-state linearizability. However, approaches using these properties are unavoidably limited to specific classes of mathematical models. To generalize design procedures and to account for parameter uncertainties as well as modeling errors, an interval arithmetic approach for verified simulation of continuoustime...

An example of the knowledge based controller-design and evaluation.

Oto Tezak (1999)

Mathware and Soft Computing

Similarity:

Knowledge based controller for a balance control model is presented in this paper. The design of the controller was based on the human control of the same process. Developed controller is tested by means of simulation and operation on the laboratory balance control model. The simulation results of the controller as well as a statistical description of the experiments with developed controller and human control is presented in the paper. Verification is based on experiments with an intelligent...

Actuator fault tolerance in control systems with predictive constrained set-point optimizers

Piotr M. Marusak, Piotr Tatjewski (2008)

International Journal of Applied Mathematics and Computer Science

Similarity:

Mechanisms of fault tolerance to actuator faults in a control structure with a predictive constrained set-point optimizer are proposed. The structure considered consists of a basic feedback control layer and a local supervisory set-point optimizer which executes as frequently as the feedback controllers do with the aim to recalculate the set-points both for constraint feasibility and economic performance. The main goal of the presented reconfiguration mechanisms activated in response...