Displaying similar documents to “Residual generator fuzzy identification for automotive diesel engine fault diagnosis”

Generalized reasoning about faults based on the diagnostic matrix

Michał Bartyś (2013)

International Journal of Applied Mathematics and Computer Science

Similarity:

This paper introduces a set of comprehensive general reasoning rules about single faults based on a diagnostic matrix. The reasoning scheme unifies inference about faults based on a conventional binary diagnostic matrix, a two- and three-valued fault isolation system as well as on their fuzzy counterparts. There are introduced and defined notions of alternative and dominant fault signatures, fuzzy fault signatures as well as a matrix of alternative signatures. This matrix is supposed...

Fuzzy diagnostic reasoning that takes into account the uncertainty of the relation between faults and symptoms

Jan Kościelny, Michał Syfert (2006)

International Journal of Applied Mathematics and Computer Science

Similarity:

Knowledge about the relation between faults and the observed symptoms is necessary for fault isolation. Such a relation can be expressed in various forms, including binary diagnostic matrices or information systems. The paper presents the use of fuzzy logic for diagnostic reasoning. This method enables us to take into account various kinds of uncertainties connected with diagnostic reasoning, including the uncertainty of the faults-symptoms relation. The presented methods allow us to...

Nonlinear actuator fault estimation observer: An inverse system approach via a T-S fuzzy model

Dezhi Xu, Bin Jiang, Peng Shi (2012)

International Journal of Applied Mathematics and Computer Science

Similarity:

Based on a Takagi-Sugeno (T-S) fuzzy model and an inverse system method, this paper deals with the problem of actuator fault estimation for a class of nonlinear dynamic systems. Two different estimation strategies are developed. Firstly, T-S fuzzy models are used to describe nonlinear dynamic systems with an actuator fault. Then, a robust sliding mode observer is designed based on a T-S fuzzy model, and an inverse system method is used to estimate the actuator fault. Next, the second...

Robust dynamic output feedback fault-tolerant control for Takagi-Sugeno fuzzy systems with interval time-varying delay via improved delay partitioning approach

Chao Sun, Fuli Wang, Xiqin He (2016)

Open Mathematics

Similarity:

This paper addresses the problem of robust fault-tolerant control design scheme for a class of Takagi-Sugeno fuzzy systems subject to interval time-varying delay and external disturbances. First, by using improved delay partitioning approach, a novel n-steps iterative learning fault estimation observer under H ∞ constraint is constructed to achieve estimation of actuator fault. Then, based on the online estimation information, a fuzzy dynamic output feedback fault-tolerant controller...

Observer-based fault-tolerant control against sensor failures for fuzzy systems with time delays

Shaocheng Tong, Gengjiao Yang, Wei Zhang (2011)

International Journal of Applied Mathematics and Computer Science

Similarity:

This paper addresses the problems of robust fault estimation and fault-tolerant control for Takagi-Sugeno (T-S) fuzzy systems with time delays and unknown sensor faults. A fuzzy augmented state and fault observer is designed to achieve the system state and sensor fault estimates simultaneously. Furthermore, based on the information of on-line fault estimates, an observer-based dynamic output feedback fault-tolerant controller is developed to compensate for the effect of faults by stabilizing...

Fault diagnosis and fault tolerant control using set-membership approaches: Application to real case studies

Vicenç Puig (2010)

International Journal of Applied Mathematics and Computer Science

Similarity:

This paper reviews the use of set-membership methods in fault diagnosis (FD) and fault tolerant control (FTC). Setmembership methods use a deterministic unknown-but-bounded description of noise and parametric uncertainty (interval models). These methods aims at checking the consistency between observed and predicted behaviour by using simple sets to approximate the exact set of possible behaviour (in the parameter or the state space). When an inconsistency is detected between the measured...

Actuator fault diagnosis for flat systems: A constraint satisfaction approach

Ramatou Seydou, Tarek Raissi, Ali Zolghadri, Denis Efimov (2013)

International Journal of Applied Mathematics and Computer Science

Similarity:

This paper describes a robust set-membership-based Fault Detection and Isolation (FDI) technique for a particular class of nonlinear systems, the so-called flat systems. The proposed strategy consists in checking if the expected input value belongs to an estimated feasible set computed using the system model and the derivatives of the measured output vector. The output derivatives are computed using a numerical differentiator. The set-membership estimator design for the input vector...

Detection and identification of loss of efficiency faults of flight actuators

Daniel Ossmann, Andreas Varga (2015)

International Journal of Applied Mathematics and Computer Science

Similarity:

We propose linear parameter-varying (LPV) model-based approaches to the synthesis of robust fault detection and diagnosis (FDD) systems for loss of efficiency (LOE) faults of flight actuators. The proposed methods are applicable to several types of parametric (or multiplicative) LOE faults such as actuator disconnection, surface damage, actuator power loss or stall loads. For the detection of these parametric faults, advanced LPV-model detection techniques are proposed, which implicitly...